1, pot heat evenly distributed

Hot water spray system in the treatment of the tank on the four corners of each tray has a series of nozzle, set between each layer tray, so wide range of spray patterns can be obtained. Because from the vertical installation in the tray on the four corners of the nozzle, continuous spray water, make the tank temperature at all stages of the sterilization process remain very stable, ensure the F value change and cooking the phenomenon such as excessive decrease to a lower limit.

2, warming faster

Because only a small amount of circulating water pot, and USES the high efficiency heat exchanger (98%), so the fast food warming, in general, when steam pressure is 0.6 Mpa, food rose from 20 degrees to 121 degrees, only 8 minutes, this can be bigger limit to keep food flavor and color, also can reduce energy consumption.

3, indirect heating and cooling, prevent secondary pollution

Indirectly through the plate heat exchanger in the circulating water heating or cooling, prevent secondary pollution.

4, suitable for various packing materials

Because in the process of cooling, not directly to the pot into the cold water, so for the fragile glass bottle packaging, can adopt soft cooling speed, avoid due to the large temperature difference caused the broken bottle. This characteristic is also suitable for shellfish, such as clams, temperature and temperature difference is too big, or heating temperature difference too metropolitan cause broken shell.

5, improve the pressure control, is suitable for gas packaging sterilization

Pressure balance system is important for containing gas packaging sterilization, especially in the heating or cooling stage, need accurate pressure control. Control system can handle tank temperature and pressure for continuous monitoring, and the tank pressure correction to make it accordingly with the pressure inside the packaging. Packing for containing percentage of filling air or gas, or seal in the vacuum packaging sterilization can be processing, and will not make the packaging or its contents were damaged or deformation. This system is different from other systems, can be applicable to the product of all pressure mode into program input in the computer in advance.

6, the control system

(1) all the time by the sensors and automatic control valve.

(2) the pressure and temperature in the digital display.

(3) the recorder to record the curves of temperature and pressure.

(4) pressure sensors, temperature sensors, PLC, man-machine interface, etc. The use of imported components.